 |
 SIZE SELECTION |
|
| To determine which size terminator best meets your requirements: |
|
- Determine cable dimensions, either "Center Strip" or "End Strip", using the diagrams at right.
Center Strip
End Strip
- Refer to cable dimension table below.
|
| CABLE DIMENTIONS |
|
| Size |
G
Min. |
F
Min. |
E
Max. |
H
Max. |
Marking
Code
83519/1 |
Part
Number |
Marking
Code
83519/2 |
Part
Number |
| 1 |
.020 |
.035 |
.105 |
.075 |
S0101S |
H-M-1 |
S02XXS |
H-ML-1,6,11,16 |
| 2 |
.030 |
.055 |
.145 |
.105 |
S0102S |
H-M-2 |
S02XXS |
H-ML-2,7,12,17 |
| 3 |
.050 |
.085 |
.200 |
.170 |
S0103S |
H-M-3 |
S02XXS |
H-ML-3,8,13,18 |
| 4 |
.070 |
.130 |
.255 |
.235 |
S0104S |
H-M-4 |
S02XXS |
H-ML-4,9,14,19 |
| 5 |
.100 |
.170 |
.300 |
.275 |
S0105S |
H-M-5 |
S02XXS |
H-ML-5,10,15,20 |
| INSTALLATION INSTRUCTIONS |
|
| Preparation of ground lead (if required). Strip insulation as shown below. |
 |
| Preparation of shielded cable. Strip insulation as shown below. |
Center Strip |
End Strip |
|
| TERMINATION ASSEMBLY |
|
| Assemble components as shown below. Make sure no loose strands are present. Ground lead may be front or rear entry. |
Center Strip |
End Strip |
|
| HEATING OF ASSEMBLY |
|
- Use one of your preferred heating tools with appropriate reflector
- Direct heat, either infrared or conventional, at so preform until substrates have wet and a proper fillet is formed
- If necessary apply heat to remainder of device to assure proper installation
|
|
|
| For further information please contact SEIP |
|
|
 |
1-800-758-3515
(US/Canada) |
|
1-760-761-0607
(Outside US/Canada) |
 |
E-mail SEIP |
|
|
|
|
|